Cutting Laminate Strips

Posted by pranko at 4:46 PM Post a Comment

Purchase enough formica sheets to cover the areas you want to laminate. This meant cutting it to size and installing laminate countertop edge strips.

Two Strips Laminate Floor Better Selection For Study Room

At times a straight edge board in combination with a router is used for milling the plastic.

Cutting laminate strips. Place strips of masking tape over the cut lines. Apply strips of masking tape where you will mark the cutting lines. Place a scrap board such as a 1 x 2 centered over the cutout so it extends.

Drill a 3 8 inch starter hole down through the countertop at each corner of the cutout. How to cut formica measuring marking and masking cut lines measure the area you wish to laminate with a tape measure. Start our by watching our video and then follow the step by step instructions to guide you through the process.

Cut the wilsonart or. Mark the cutout on the masking tape. Then use a few small pieces of masking tape to hold the strip in place while the glue dries.

Transfer the measurements for the strips to the back of wilsonart or formica laminate. For more information plans and helpful links. There are several different ways to cut plastic laminate into strips.

Shift the score line to the table edge and break the laminate again. How to cut wilsonart formica laminate into strips step 1. Many times throughout renovations you will need to decide whether or not spending extra money is actually worth it.

Draw the knife across the surface applying firm pressure two or three times. The most accurate tool for cutting plastic laminate edges for cabinets or countertops is called a laminate slitter. Install a fine toothed blade on your table or circular saw.

Turn the laminate one quarter turn and align the square along the next cut line. To make a sink cutout. Measure the laminate with a measuring tape.

Some people use table saws for making the thin edging pieces. Repeat for any additional cuts. To ensure a straight cut it s best to construct a.

Simply cut the right length on a table saw then apply a bead of glue along the edge of the laminate board. Handheld power saws cut on the upstroke so you ll minimize chipping by placing the laminate face down and cutting from the back of the sheet. Carefully press the wood strip in place making sure the edges are even.

Mark the cut lines on the formica with a pen or pencil.

Installing Laminate Flooring Finishing Trim And Choosing